Storage; Disposal; What If There Are Problems; Technical Data - Beurer HK 48 Cosy Instrucciones Para El Uso

IMPORTANT
Please note that the cover with integrated heating pad must not be dry cleaned, wrung out, tumble
dried, put through a mangle or ironed.
Immediately after washing, reshape the cover with integrated heating pad to its original dimensions
while it is still damp and spread it out flat on a clothes horse to dry.
IMPORTANT
• Do not use pegs or similar items to attach the cover with integrated heating pad to the
clothes horse. Failure to observe this may result in damage to the item.
• Do not reconnect the controller to the heating pad until the cover with integrated heating pad, the
plug-in connector and the inner pad are completely dry. Otherwise there is a risk of electric shock.
Fit the inner pad back into the cover with integrated heating pad.
WARNING
• Never switch the heating pad on to dry it! Otherwise there is a risk of electric shock.

6. Storage

If you do not plan to use the heating pad for a long period of time, we recommend that you store it in the
original packaging. For this purpose, disconnect the controller from the heating pad by unplugging the
plug-in coupling.
CAUTION
Please allow the heating pad to cool down before storing. Otherwise the heating pad may be damaged.
To avoid sharp folds in the heating pad, do not place any objects on top of it while it is being stored.

7. Disposal

Please dispose of the heating pad in accordance with Directive on Waste Electrical and Electronic
Equipment (WEEE). In case of queries, please contact the
municipal authorities responsible for waste disposal in your area.

8. What if there are problems?

Problem
The temperature settings are not illuminated while
- the controller is properly connected to the heating pad;
- the mains plug is connected to a working socket;
- the sliding switch is set to 1, 2 or 3.

9. Technical data

See the rating label on the heating pad.
Cause
The safety system has
switched the heating
pad off permanently.
14
Solution
Send the heating pad
and the controller for
servicing.