HSM Classic 225.2 Instrucciones De Servicio página 12

https://www.supplychimp.com/
6 Operation
WARNING
Before switching the machine on,
make sure that you observe all
safety instructions.
Switching the paper shredder on
• Press rocker switch .
 Rocker switch locks in place.
 Green LED lights.
 Paper shredder is ready for op-
eration (standby).
Feed paper
• Insert the paper to be de-
stroyed. See "Technical data"
for sheet capacity.
 Automatic start stop control
starts the cutting system auto-
matically.
 Paper is pulled into cutting
system and shredded.
 When the paper fee ding
opening is free again, the cut ting sy stem au-
to ma tical ly swit ches off af ter app rox. 3 sec.
and returns to standby.
Shredding CDs and disks (see "Prop-
er Use")
Swit ching paper shredder off
• Tap rocker switch .
 Switch returns to ze ro po si ti on.
12
Feed CDs and disks
through the slot in the
safety element. This
protects you from splin-
ters.
7 Troubleshooting
Paper jam
You have fed in too much paper.
 R ed LED lights.
 T he cutting device runs in re-
verse for approx. 2 seconds
automatically.
 P a per is pus hed out.
Notice Do not press rocker switch alter-
nately forwards/backwards ( - ). Cutting
unit could be damaged.
• Pull out the paper from the paper
feed opening.
If the paper is too low and cannot
be taken out: Activate the rocker
switch  several times briefl y.
Light barrier must be free of ob-
stacles.
• Acknowledge the fault by switch-
ing the machine off and on again.
• Se pa ra te pa per stack.
• Press rocker switch .
• Feed in pa per successively.
Shredded material container full
 R ed LED lights.
 Paper shredder switches off.
Notice Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
• Switch equipment off. To do this
tap rocker switch .
• Remove full shredded material
bag and insert new bag.
Door open
 R ed LED lights.
 Paper shredder switches off.
• Check whether front door is
closed properly.
For all other malfunctions, check whether
the motor was overloaded before contacting
our customer service. Let the shredder cool
down for approx. 15 – 20 mins. before using
it again.
Classic 225.2
english
06/2014