GYS NEOPULSE 320 C Manual Del Usuario página 46

TIG DC TACK WELDING
• SPOT
This welding mode allows the parts to be pre-assembled before welding. Spot welding can be done manually using the trigger or timed at a predefined
pace. This spot welding timer is useful for better reproducibility and when making non-oxidized welds (accessible in the advanced menu).
Settings Designation
Pre-gas
Welding current
Spot
Post-gas
Access to some welding parameters depends on the selected display mode: Settings/User Level: Easy, Expert, Advanced.
• TACK
The welding mode also allows parts to be pre-assembled before welding, but this time in two phases: a first phase of pulsed DC concentrating the arc
for better penetration, followed by a second phase of standard DC widening the arc and thus the bath to ensure the point.
The adjustable duration of each phase enables control of the weld time for better spot welding results and an non-oxidised spot.
Settings Designation
Pre-gas
Welding current
Pulse duration
Pulse frequency
Non-pulsed duration
Post-gas
Access to some welding parameters depends on the selected display mode: Settings/User Level: Easy, Expert, Advanced.
• Welding in E.TIG mode
This mode allows constant power welding by measuring arc length variations in real time to ensure constant bead width and penetration. In case the
assembly requires the welding power to be controlled, the E.TIG mode can be used as it is designed to ensure that the welding power remains the
same regardless of the position of the torch.
46
NEOPULSE 320 C
Adjustable
settings
0 - 60 secs. Torch purge time and to protect the area with gas before ignition
5 - Imax Welding current.
, 0 - 60
Manual or a defined time.
secs.
Duration for which gas is released after the arc has stopped. It protects the weld
0 - 60 secs.
pool and the electrode against oxidisation when the metal is cooling down.
Adjustable
settings
0 - 60 secs. Torch purge time and to protect the area with gas before ignition
5 - Imax Welding current.
, 0 - 60
Pulsation phase controlled manually or for a defined duration
secs.
0.1 - 2500 Hz Pulse frequency
, 0 - 60
Smooth current phase controlled manually or for a defined duration
secs.
Duration for which gas is released after the arc has stopped. It protects the weld pool
0 - 60 secs.
and the electrode against oxidisation when the metal is cooling down.
Description & advice
Description & advice
EN