Milwaukee M12 HAMMERVAC Manual Del Operador página 5

Installing/Removing the Bit
Slide the bit through the nozzle and then install
into the tool according to the tool manufacturer's
instructions. For best results, use a bit 6" in length
or shorter.
Fitting the HAMMERVAC™ to the Tool and Bit
For proper suction and depth
control, position the nozzle as-
sembly so the bit is flush with
the forward face of the nozzle:
1. Press and hold the tool and
bit adjustment button.
2. Push in the nozzle assembly
until the bit is flush with the
front face of the nozzle.
3. Release the tool and bit ad-
justment button.
NOTE: Fully extend
HAMMERVAC™ before storing
to preserve spring life.
Setting the Drilling Depth
1. Fit the HAMMERVAC™ to the Tool and Bit.
2. Press and hold the depth gauge button and slide
the depth gauge to the desired depth. The drill-
ing depth is the last visible measurement shown
when viewed from the top of the tool. To ensure
the HAMMERVAC™ is properly set to the tool,
bit, and desired depth, always drill a test hole.
To ensure the HAMMERVAC™ is properly set to
the tool, bit, and desired depth, always drill a test
hole.
Drill Depth
NOTE: When using the optional Crevice Tool ac-
cessory, set the drill depth to 0.
Incorrect
Correct
the
Incorrect
OPERATION
To reduce the risk of fire and in-
WARNING
jury, do not use to pick up flam-
mable or combustible materials. Empty dust box
completely before use.
To reduce the risk of injury, wear safety goggles
or glasses with side shields.
To reduce the risk of injury, wear a dust mask or
use an OSHA compliant dust extraction solution.
Using the Power Switch
AUTO To set the HAMMERVAC™ to start auto-
matically as a hole is being drilled, move
the power switch to the AUTO position.
When the nozzle assembly is pushed in,
the HAMMERVAC™ will run. NOTE: The
HAMMERVAC™ will continue to run 3-5
seconds after the tool has fully extended to
ensure all dust is captured in dust box.
ON
To turn the tool ON, move the power switch
to the ON position. The HAMMERVAC™ will
run continuously.
OFF To turn the tool OFF, move the power switch
to the OFF position.
Proper Operation
1. Empty the dust box.
2. Install and position the nozzle assembly to the
desired side.
3. Attach side handle clamping collar assembly and
grip to tool.
4. Fit the HAMMERVAC™ to the Tool and Bit.
5. Set the drill depth.
6. Install the battery pack.
7. Turn HAMMERVAC™ to ON or AUTO.
8. Begin use according to tool manufacturer instruc-
tions.
9. Always hold the tool securely using both handles
to maintain control.
10. Stop and empty dust box:
• When suction decreases
• When dust begins to come through the bit
brush.
5