Dyna-Glo DGP552SSN Manual Del Usuario página 17

ASSEMBLY INSTRUCTIONS
Front View
CONNECTING THE GRILL TO THE NATURAL GAS SUPPLY
agency. The supply connection must be made in accordance with local codes or, in the absence
of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, in the USA, of the
Natural Gas and Propane Installation Code, CSA B149.1, in Canada.
• A properly sized manual shut-off valve must be installed between the frill and the gas supply piping.
• The grill and its individual shut-off valve must be disconnected from the gas supply piping system
• The grill must be isolated from the gas supply piping system by closing its individual manual shut-
valve.
TO CONNECT:
1. Ensure that the natural gas shut-off valve is closed.
2. Remove the protective rubber caps from the plug
3. Retract the sleeve on the coupling as illustrated.
4. Insert the plug and release the sleeve as illustrated.
5. Push the plug into the sleeve until the sleeve snaps
forward to lock the plug in the coupling.
6. Open the natural gas shut-off valve.
TO DISCONNECT:
1. Close natural gas supply at shut-off valve.
2. Push the sleeve back and gently pull out the plug.
3. Replace the protective rubber caps on the plug and
Fully Assembled
17
Rear View
Retract Sleeve
R
Release Sleeve