Replacement Or Installation Of Rotor - OHAUS Frontier FC5306 Manual De Instrucciones

EN-4

2.2 Replacement or Installation of Rotor

1. When the machine is delivered from the factory, the seizing shaft sleeve
and angle rotor are firmly fixed on the shaft of the drive motor.
2. If it is necessary to dismantle an installed rotor, the user should hold the
outside edge of the rotor, and push the protruding clamp towards its
center with two thumbs, then lift the rotor upwards.
3. To reinstall rotor, align the oval hole of rotor over the clamp, then gently
press down the rotor until the clamp clicks into place.
角转头
Angle Rotor
Clamp
Motor Shaft Sleeve
电机轴套
TM
Frontier FC5306