Installation; Maintenance & Servicing; Environmental Conditions; Equipment Disposal - OHAUS ISICMBCDG Manual De Instrucciones

INSTALLATION

Upon receiving the Ohaus Incubating/Cooling Shaker, check to ensure that no damage
has occurred during shipment. It is important that any damage that occurred in
transport is detected at the time of unpacking. If you do find such damage the carrier
must be notified immediately.
After unpacking, place the Incubating/Cooling Shaker on a level bench or table, away
from explosive vapors. Secure to an immovable work surface by pressing down on
the four (4) corners of the unit, creating a strong suction to the work surface (DO
NOT place on a bench mat). Ensure that the surface on which the unit is placed will
withstand typical heat produced by the unit. Always place the unit on a sturdy work
surface.
The Incubating/Cooling Shaker is supplied with a power cord that is inserted into
the IEC connector on the back of the unit first, then it can be plugged into a properly
grounded outlet. The 120V unit plugs into a 120 volt, 50/60 Hz source. The 230V unit
plugs into a 230 volt, 50/60 Hz source.
MAINTENANCE & SERVICING
The Incubating/Cooling Shaker is built for long, trouble-free, dependable service. No
lubrication or other technical user maintenance is required. However at least every
three (3) months you should:
• Unplug the unit.
• Remove any accumulated dirt from the base and tray.
• Check all accessible items to make sure they are properly tightened.
The unit should be given the care normally required for any electrical appliance. Avoid
wetting or unnecessary exposure to fumes. Spills should be removed promptly. DO NOT
use a cleaning agent or solvent on the front panel or lid which is abrasive or harmful
to plastics, nor one which is flammable. Always ensure the power is disconnected
from the unit prior to any cleaning. If the unit ever requires service, contact your
Ohaus representative.

ENVIRONMENTAL CONDITIONS

Operating Conditions: Indoor use only.
Temperature: 5 to 40°C (41 to 104°F)
Humidity: maximum 80% relative humidity, non-condensing
Altitude: 0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity: maximum 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.

EQUIPMENT DISPOSAL

This equipment must not be disposed of with unsorted waste. It is your responsibility to
correctly dispose of the equipment at life-cycle-end by handing it over to an authorized
facility for separate collection and recycling. It is also your responsibility
to decontaminate the equipment in case of biological, chemical and/or
radiological contamination, so as to protect the persons involved in the
disposal and recycling of the equipment from health hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure that
your equipment is recycled in a manner that protects human health.
EN
2