GE 26 Serie Manual Del Propietário página 32

INSTALLING THE REFRIGERATOR
REPLACING THE FREEZER DOOR
10
Tighten screws completely. (There are four
C
10 mm hex-head bolts.)
REPLACE THE FREEZER BASKET
Replace the freezer basket by lowering it into the frame.
REPLACE THE FREEZER BIN
Hook the ends of the freezer bin into both brackets, and
push down until they lock into place. (See page 19.)
Installation Instructions
(cont.)
32
(cont.)
CONNECTING THE REFRIGERATOR
11
TO THE HOUSE WATER LINE
A cold water supply is required for automatic icemaker
operation. If there is not a cold water supply, you will
need to provide one. See Installing the Water Line
section.
NOTES:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
• If your refrigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's water valve. Install it in the water line
near the refrigerator. If using GE SmartConnect
Refrigerator Tubing Kit, you will need an additional
tube (WX08X10002) to connect the filter. Do not cut
plastic tube to install filter.
A
If you are using copper tubing, place a compression
nut and ferrule (sleeve) onto the end of the tubing
coming from the house cold water supply.
If you are using the GE SmartConnect
the nuts are already assembled to the tubing.
If you are using copper tubing, insert the end
B
of the tubing into the refrigerator connection,
at the back of the refrigerator, as far as possible.
While holding the tubing, tighten the fitting.
If you are using GE SmartConnect
the molded end of the tubing into the refrigerator
connection, at the back of the refrigerator, and tighten
the compression nut until it is hand tight. Then tighten
one additional turn with a wrench. Overtightening may
cause leaks.
C Fasten the tubing into the clamp provided to hold it in
position. You may need to pry open the clamp.
Refrigerator
Connection
SmartConnect
™
Tubing
™
tubing,
™
tubing, insert
™
Ferrule
1/4"
(sleeve)
Compression
Nut