Safety Information - Amprobe 5XP-A Manual De Uso

5XP-A
NON
MIN MAX
CONTACT
VOLTAGE
OFF
750 1000
200
20
V
2
200
m
20M
2M
200k
20k
2k
200
1.5V 9V 200
BATT
CAT 1000V
CAT
CAT
V COM
BATT 9V
MAX
1000V
200mA MAX
750V
FUSED

Safety Information

• The XP Series Digital Multimeters conform to EN61010-1, Rev-2; CAT I 1000 V,
CAT II 600 V, CAT III 300 V, class 2 and pollution deg.2; CSA 22.2 -1010-1.
•
This instrument is EN61010-1 certified for Installation Category I (1000V). It
may only be used to make measurements on energy limited circuits within
equipment and not directly connected to mains.
•
This instrument is EN61010-1 certified for Installation Category II (600 V). It is
recommended for use with local level power distribution, appliances, portable
equipment, etc, where only smaller transient overvoltages may occur, and not
for primary supply lines, overhead lines and cable systems.
•
This instrument is EN61010-1 certified for Installation Category III ( 300 V). It is
recommended for use in distribution level and fixed installations, as well as
lesser installations, and not for primary supply lines, overhead lines and cable
systems.
• Do not exceed the maximum overload limits per function (see specifications)
nor the limits marked on the instrument itself. Never apply more than 1000 V
dc/750 V ac rms between the test lead and earth ground.
• Inspect the DMM, test leads and accessories before every use. Do not use any
damaged part.
• Never ground yourself when taking measurements. Do not touch exposed
circuit elements or test probe tips.
• Do not operate the instrument in an explosive atmosphere.
• Exercise extreme caution when: measuring voltage >20 V // current >10 mA //
AC power line with inductive loads // AC power line during electrical storms //
current, when the fuse blows in a circuit with open circuit voltage >1000 V //
servicing CRT equipment.
• Always measure current in series with the load – NEVER ACROSS a voltage
source. Check fuse first. Never replace a fuse with one of a different rating.
• Remove test leads before opening the case.
5XP-A
HOLD
200
20
V
2
200
m
200
2m
20m
200
m
200m
20m
2m
A
600V
300V
mA
BATT 1.5V
15XP-A
15XP-A
NON
RANGE HOLD
CONTACT
VOLTAGE
A
mA
A
A
mA
A
V
V
OFF
auto-off
CAT 1000V
CAT 600V
CAT 300V
V COM A
LOGIC
MAX
1000V
2A MAX
750V
FUSED
2
35XP-A
35XP-A
NON
RANGE HOLD
CONTACT
VOLTAGE
OFF
V V
A A
mA mA
2A A
HZ A
mA
400
A
˚C
1000 400
1832
˚F auto-off
CAT 1000V
CAT 600V
CAT 300V
V COM A
Hz Temp
MAX
1000V
2A MAX
750V
FUSED