Designated Use; Installation Instructions - Zivan NG3 Manual Del Usuario

ATTENTION: To reduce the risk of
electric shock, do not remove cover.
Refer servicing to qualified service personnel.
Disconnect the mains supply before connecting
or disconnecting the links to the battery.
Read the Instruction Manual carefully
before use. Verify that the selected
charge curve is suitable for the type
of battery You have to re-charge.
Explanation of Graphical Symbols:
Is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the equipment's enclosure; that may be
of sufficient magnitude to constitute a risk of electric shock to
persons.
Is intended to alert the user to the presence of important operating
and maintenance (servicing) instructions in the literature
accompanying the equipment.
This product is covered by warranty. The relative warranty certificate is attached to the Instructions Manual.
If the Manual is not provided with this certificate, please ask your retailer for a copy.
Information contained in this Manual relates to ZIVAN S.r.l. property which reserves the right to supply for the exclusive use of
customers. No other use is allowed without a written authorization supplied by ZIVAN S.r.l.
ZIVAN S.r.l. will be not responsible for inaccuracies contained in this manual due to print or translation errors. ZIVAN S.r.l. has the right
to make changes or improvements, also for the user interest, without prejudicing the essential characteristic of operation and safety.

Designated use

The NG3 battery charger is an electronic appliance, only for professional use,
on the firmware installed. According to the application and the software programmed it is also allowed as power supply use.
Use safety instructions
Battery charger NG3 has been designed to provide safety and reliable. It is necessary to observe the following precautions in order to
avoid damage to persons and to the battery charger:
Read the installation instructions contained in this Manual carefully. For further information put the Manual in a proper place.
•
This charger must be installed by qualified personnel.
•
Risk of electric shock. If the charger is provided with a plug, connect it only to an outlet that has been properly installed and
•
grounded in accordance with all local codes and ordinances.
A grounded outlet is required to reduce risk of electric shock. Do not use ground adapters or modify plug
•
Do not touch uninsulated portion of output connector or uninsulated battery terminal.
•
To avoid damaging the power cord, do not put anything on it or place it where it will be walked on. If the cord becomes damaged or
•
frayed, refer to qualified personnel for replacing it immediately.
Do not operate charger if the AC supply cord is damaged or if the charger has received a blow, been dropped, or otherwise
•
damaged in any way. Refer all repair work to qualified personnel.
For safety and electromagnetic compatibility, the battery charger has a 3-prong plug as a safety feature, and it will only fit into an
•
earthed outlet. If you can not plug it in, chances are you have an older, non-earthed outlet; contact an electrician to have the outlet
replaced. Do not use an adapter to defeat the grounding.
If you are using an extension cord or power strip, make sure that the total of the amperes required by all the equipment on the
•
extension is less than the extension's rating.
Avoid recharging of non-rechargeable batteries.
•
Do not use to charge starter batteries installed on board of thermal engine cars.
•
Verify that the nominal voltage of the battery to be re-charged corresponds to the voltage stated on the battery charger name plate.
•
Verify that the selected charging curve is suitable for the type of battery to be re-charged. In case of doubt, consult Your retailer.
•
The producer will not accept any responsibility in case of mistaken choice of the charging curve that may cause irreversible
damage to the battery.
To recharge Lead Acid batteries: WARNING: Explosive Gas – Avoid flames and sparks. The battery must be positioned in a
•
correctly cooled place.
Ensure that no flammable materials are stored in the area surrounding the charger.
•
If the battery charger does not work correctly or if it has been damaged, unplugged it immediately from the supply (turn off the
•
switch) and from the battery socket and contact a retailer.
Do not try to service the battery charger yourself. Opening the cover may expose you to shocks or other hazards.
•
Disconnect the mains supply or turn the charge off (turn off the switch) before connecting or disconnecting the links to the battery.
•

Installation instructions

This charger should be installed only by qualified personnel
•
Do not operate on the charger while it is connected to the grid. Always disconnect it before.
•
Do not modify or repair the charger. Only authorized personnel could do it
•
Only installation instruction listed in this manual could be done by qualified personnel. Further action are avoided.
•
D01737-08
NG3 Battery Charger
During operation it is possible that some parts of
the product reach high temperatures.
The product suffers from moisture: ensure installation
prevents any liquids
developed to recharge different battery types depending
entering.
Warning to user:
some contact surfaces may become
hot.
Warning to user: the product suffers from
humidity.
English
11