Installing The Side Shelf; Installing The Grease Tray - Louisiana Grills LG Serie Manual De Instrucciones

• Take one cabinet door and align the edge with the hinge pins to the
outside edge of the front of the cart. Insert the bottom pin into the
pivot hole on the side of the bottom shelf, then push down on the
spring-loaded top pin, and lock into the hole on the main barrel brace.
Repeat same installation for other cabinet door. Note illustration 5B.
IMPORTANT: The cabinet doors should swing freely once installed, and
line up with the door stopper and door magnet. If unlevel, ensure the
top and bottom pins of the cabinet doors are inserted correctly.

6. INSTALLING THE SIDE SHELF

Parts Required:
1 x Side Shelf (#17)
4 x Side Shelf Tool Hook (#C)
1 x Side Shelf Handle (#18)
2 x Side Shelf Bracket (#16)
Screw (#A)
2 x
Screw (#B)
8 x
Installation:
• Turn the side shelf upside down. On the edge of the side shelf with four
holes, install the tool hooks into each hole along the edge. Tool hooks
will secure to the self-clinching nut that is pre-mounted on the inside.
• Next, on the short edge of the side shelf with two holes, align the
handle with the holes, then secure by hand-tightening two screws
into the handle. Last, secure the two side shelf brackets using two
screws on each. Note illustration 6A.
• From underneath, secure the side shelf to the side panel of the main
barrel using two types of screws. Note illustration 6B for proper screw
placement.
NOTE: Do not tighten any screws completely until all screws have
been installed. Once all screws are installed, then tighten securely.
IMPORTANT: Avoid using the side shelf to move or lift the grill. The
weight of the unit may cause the side shelf to break, which is not
covered by warranty.

7. INSTALLING THE GREASE TRAY

Parts Required:
Grease Tray (#19)
1 x
1 x Grease Tray Handle (#18)
2 x Screw (#B)
Installation:
• Secure the grease tray handle onto the grease tray using two screws.
• Slide the grease tray into the tray opening on the front panel of the
unit. The grease tray is completely inserted once the front of the tray
is flush with the front panel of the unit.
5B
6A
#B
#B
#B
BOTTOM VIEW
6B
#A
#B
7
9