Using Parallel Effects Connection With The L1 Model I Power Stand - Bose L1 I El Manual Del Propietario

Figure 9
Using a parallel effects
connection

Using parallel effects connection with the L1 model I power stand

Note: Connecting an effects unit in parallel requires one ¼-inch unbalanced (instrument) cable,
one mono ¼-inch phone (M) to dual mono ¼-inch phone (F) "Y" cable adaptor, and one TRS split
"insert" cable (with a ¼-inch TRS connector on one side and two mono ¼-inch phone connec-
tors on the other).
1. Insert the TRS plug into the Channel 1 Insert jack on the L1 model I power stand.
2. Connect both ¼-inch plugs from the "insert" cable into both receptacles on the "Y" cable
adaptor.
3. Connect the plug of the "Y" cable adapter into the input of the effects processor.
4. Connect the ¼-inch unbalanced (instrument) cable from the output of the effects
processor to Channel 3 Line IN of the L1 model I power stand.
5. Set the effects level of the processor to full and turn the mix level of the effects processor
to full "wet".
6. Adjust the Channel 3 Level control of the L1 model I power stand for the desirable
effects mix.
Connect to
Channel 1 Insert
L1 model I power stand
TRS split "insert" cable
1/4-inch Instrument Cable
Connect to Effects
Unit OUTPUT
Connect to
Channel 3 Line IN
O
PERATING
Mono 1/4-inch Phone (M) to
dual mono 1/4-inch Phone (F)
"Y" cable adaptor
Connect to Effect Unit INPUT
Digital Effects Unit
I
NSTRUCTIONS
27