Continuity - Resistance Measurement - Chauvin Arnoux C.A. 704 Manual De Instrucciones

"Singlehanded" single pole test:
Place the tip of the black probe (connected
to the COM terminal) on the conductor to be
tested and one tip in the identification zone
for Ph/N.
In the presence of the phase (if U network >
127 V~) the red LED "PH" flashes.
NB 1 : During "single-handed" testing the
voltage indication is no longer significant.
"Twohanded" two pole test (with voltage
measurement):
Place the red tip on the first conductor, the
black tip on the second conductor to be
tested and a finger on the Ph/N identification
zone.
The PH LED flashes if the black tip is
connected to the phase.
The voltage value between the terminals is
indicated on the digital display.
Characteristics and field of use:
- U network > 127 V
Warning: U max with respect to ground = 600 V
- Frequency: 50...60 Hz - ± 5%
WARNING:
If the phase LED is blinking and some Volts are
displayed, make certain that the test probe has
a good electrical contact.
6. CONTINUITY TESTING
RESISTANCE MEASUREMENT
Always run a self-test before using your Always run a self-test before using your Always run a self-test before using your Always run a self-test before using your Always run a self-test before using your
m m m m m ultimeter ultimeter. . . . . ultimeter ultimeter ultimeter
Never use it if the self-test is wrong. Never use it if the self-test is wrong. Never use it if the self-test is wrong.
Never use it if the self-test is wrong. Never use it if the self-test is wrong.
Before performing a continuity test make Before performing a continuity test make
Before performing a continuity test make Before performing a continuity test make Before performing a continuity test make
sure that the circuit to be tested is de- sure that the circuit to be tested is de- sure that the circuit to be tested is de- sure that the circuit to be tested is de- sure that the circuit to be tested is de-
energized. energized. energized. energized. energized.
Place the two test probes on the circuit to be
tested. If the display indicates a voltage level,
stop the test: the circuit is energized.
Press the self test pushbutton.
18