Bosch B36CT Serie Instrucciones De Uso Y Montaje página 11

You can adjust the angle of the drawer:
Open the drawer as far as it will go and remove
1.
the bin.
Remove the center screws on both sides.
2.
Note: If you want to reset the drawer to the factory
settings, keep the screws.
Installation and connection en-us
Loosen the upper and lower screw on both sides.
3.
Note: Do not remove the screws.
Move drawer on the lower screw to the left or
4.
right into the required position and tighten the
screw.
Retighten all the screws.
5.
To check the position, close the drawer and
6.
correct if necessary.
11