Features; Assembly - Ryobi P260 Manual Del Operador

PRODUCT SPECIFICATIONS
Motor .................................................................. 18 Volt DC
Anvil ...............................................................1/2 in. Square
Gear Train .......................................................... One Speed
Switch .............................. (VSR) Variable Speed Reversible
KNOW YOUR IMPACT WRENCH
See Figure 1, page 9.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all op-
erating features and safety
ANVIL
The square 1/2 in. anvil with detent retention pin provides
easy installation and removal of sockets by pushing them
on or pulling them off the shank.
UNPACKING
This product has been shipped completely assembled.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Impact Wrench
Operator's Manual

FEATURES

rules.

ASSEMBLY

No Load Speed ..................................0-3,000 r/min. (RPM)
Torque ................................................................... 200 ft. lb.
Impacts Per Minute ......................................... 0-3,000 IPM
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
The direction of rotation (forward/reverse/center lock)
selector located above the switch trigger will change the
direction of rotation.
IMPACTS PER MINUTE
This tool features an impact speed of 3,000 impacts per
minute.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
WARNING:
If any parts are damaged or missing do not operate this
tool until the missing parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such altera-
tion or modification is misuse and could result in a hazard-
ous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
6 — English