Briggs & Stratton Power Boss Manual Del Usuario página 9

2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
3. Run water through your garden hose for 30 seconds to
clean out any debris.
NOTICE DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F (38°C)).
4. Before connecting garden hose to water inlet, inspect
inlet screen (A). Clean screen if it contains debris or
have it replaced if damaged. DO NOT run pressure
washer if inlet screen is damaged.
5. Connect the garden hose (not to exceed 50 feet (15 m)
in length) to the water inlet. Tighten by hand.
NOTICE Using a One Way Valve (vacuum breaker or check
valve) at pump inlet can cause pump or inlet connector
damage.
• There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ON the water, press red button (B) on the gun and
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVER substitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
A
Checklist Before Starting Engine
Review the unit's assembly to ensure you have performed all
of the following.
1. Be sure to read the Operator Safety section and How to
2. Make sure handle is in place and secure.
3. Check that oil has been added to proper level in the
4. Add proper fuel to fuel tank.
5. Check for properly tightened hose connections.
6. Check to make sure there are no kinks, cuts, or damage
7. Provide a proper water supply at an adequate flow.
squeeze the trigger to purge the pump system of air and
impurities.
B
WARNING Risk of eye injury.
Spray can splash back or propel objects.
Use Your Pressure Washer in Operation section before
using pressure washer.
engine crankcase.
to high pressure hose.
9