Description Of The Washing Machine And Starting A Wash Cycle; Control Panel - Hotpoint Ariston ARGF 129 X Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Description of the washing
machine and starting a wash cycle

Control panel

GB
Detergent dispenser drawer: used to dispense
detergents and washing additives (see "Detergents and
laundry").
ON/OFF button with indicator light: switches the machine
on and off.
If the indicator light is illuminated, this indicates that the
machine is switched on.
WASH CYCLE knob: programmes the wash cycles. During
the wash cycle, the knob does not move.
SPIN SPEED button: sets the spin speed or exclude the
spin cycle completely (see "Personalisation").
TEMPERATURE button: sets the temperature or the cold
wash cycle (see "Personalisation").
DISPLAY: indicates the time remaining for the selected
wash cycle and, if a delayed start has been programmed,
the time remaining until the start of the wash cycle.
CONTROL PANEL LOCK button with indicator light:
activates or deactivates the control panel lock.
FUNCTION buttons with indicator light: used to select the
available functions. The indicator light corresponding to the
selected function will remain lit.
4
ON/OFF
button with indicator
light
Detergent dispenser drawer
WASH CYCLE PROGRESS
TEMPERATURE
SPIN SPEED
button
WASH CYCLE
knob
CONTROL PANEL LOCK
button with indicator light
WASH CYCLE PROGRESS indicator lights: used to
monitor the progress of the wash cycle.
The illuminated indicator light shows which phase is in
progress.
DOOR LOCKED indicator light: indicates whether the
door may be opened or not (see next page).
START/PAUSE button with indicator light: starts or tem-
porarily interrupts the wash cycles.
N.B. To pause the wash cycle in progress, press this
button; the corresponding indicator light will flash orange,
while the indicator light for the current wash cycle phase
will remain lit in a fixed manner. If the DOOR LOCKED
indicator light is switched off, the door may be opened.
To start the wash cycle from the point at which it was inter-
rupted, press this button again.
Standby mode
This washing machine, in compliance with new energy sa-
ving regulations, is fitted with an automatic standby system
which is enabled after about 30 minutes if no activity is
detected. Press the ON-OFF button briefly and wait for the
machine to start up again.
indicator lights
DISPLAY
button
FUNCTION
buttons with
indicator lights
DOOR
LOCKED
indicator light
START/PAUSE
button with indicator
light

Publicidad

Tabla de contenido
loading

Tabla de contenido