Using The Digital Display - Tripp-Lite AG-013B Serie Manual Del Propietário

5. Using the Digital Display

5.1 Navigating Display Menus and Submenus (Measurement)
Press the MODE button to go to the next Display menu. Press the Enter button to go to the next
submenu (Amps, kW, Volts, Hz, PF). Press and hold MODE button for 2 seconds to switch to the
first Config menu (refer to Navigating Config Menus and Submenus section). Press and hold
both the MODE and Enter button for 2 seconds to show the IP address of the connected SNMP
card. The scrolling pattern of the menus is outlined below.
Source A
Phase Current (L1)
i.3.2
Volts (L1-L2)
2.0.8
Hz (L1-L2)
15-01-272-9333FB.indb 11
A i
A i
6.0
A i
Note: Since this is a 208V model, voltages
displayed are phase-to-phase voltages
(e.g., A1 in display indicates L1-L2 voltage).
11
8/26/2015 10:04:18 AM