Display During The Cycle - Tecno-gaz Ekstraplus PT001TTM Instrucciones De Uso

7.6

Display during the cycle

As previously mentioned, after performing the following steps:
a)
Inserting the instruments
b)
Closing the door
c)
Selecting the stations and type of cycle
The cycle is launched by pressing the START button.
COMPLETE CYCLE:
The cycle is performed according to the sequence of the steps listed below and shown on the display.
DD-MM-AA hh-mm
TYPE OF CYCLE
DD-MM-AA hh-mm
COMPLETE
PHASE 1 BLEED
SCREEN B1-1
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
FINISHED CYCLE
OK
SCREEN B1-6
LUBRICATION CYCLE:
The lubrication cycle is performed according to the following steps:
SCREEN B2-1
SCREEN B2-4
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
PHASE 2 CLEAN
SCREEN B1-2
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
PHASE 5 BLEED
SCREEN B1-5
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
PHASE 1 BLEED
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
FINISHED CYCLE
OK
SCREEN B1-3
PHASE 4 LUBRICATION
SCREEN B1-4
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
PHASE 2 LUBRICATION
SCREEN B2-2
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
PHASE 3 BLEED
SCREEN B2-3
ENGLISH
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
PHASE 3 BLEED
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
23