Qlima P 432 Instrucciones De Uso página 89

3 Place a pan or appropriate tray on the floor underneath the permanent drain
tube.
4 Remove the rubber plug from the drain tube and let the water run out.
(± 0.5 litres). See fig. 13.
5 Replace the rubber plug, put the plug into the wall outlet, and switch on the
unit. Error code H8 will no longer be displayed.
G
NOTE!
When the air conditioner is in use, under normal circumstances the
condensed water will be drained through the air outlet-tube.
To drain the condensation from the lower water tank it is possible to connect a
permanent hose and holder. For instructions on how to fit this hose, see chapter I.
I
FITTING OTHER SUPPLIED COMPONENTS
Fitting the permanent condensation drain
When the air conditioner is used in the dehumidifier mode, a condensation hose must
be fitted.
1 Remove the condensation cover at the rear of the unit by turning it anti-
clockwise and remove the rubber cap from the drain (see fig. 14).
Fig. 14
2 Connect the supplied hose grommet H (see fig. 1) to this drain (see fig. 15).
Fig. 15
Fig. 13
4
89