Switch Off Gas To Stove; Combustion Control - Dovre SENSE 203GA Instrucciones De Instalacion Y Uso

1
2
3
4
1 Piezo ignition
2 On/off switch (option)
3 Eight-wire-receiver-contact
4 Microswitch
5 Piezo ignition connection (2.8x0.8mm)
6 Manual button in MAN position
7 Manual pilot regulator
8 Main valve button in OFF position
Access to the pilot is only required for igniting
with a match.
Do not exert excessive force when turning the
main valve button. The button has a slip-action
clutch that clicks until the final stops are
reached. This enables manual programming of
the flame height and the pilot standby position.
Read the safety information before continuing.
1. Turn the main valve button (8) to the OFF position,
completely clockwise
2. Turn the MANUAL button (6) to the MAN position,
completely clockwise
A manual pilot regulator and Piezo ignition
(option) are accessible when the MAN button
is in the MAN position.
3. Wait five minutes until the stove is free of gas.
Check by smell whether any gas is still present
Subject to change because of technical improvements
5
6
7
8
09-20020-244
.
.
around the stove, including near the floor.
If you detect any gas odour, stop immediately.
See the last warning in the chapter "Safety". If
no gas is present, proceed to the next instruc-
tion step.
4. Press the manual pilot regulator (7) all the way in
and continue pressing to start the pilot gas flow.
Ignition with a match:
Ignite the pilot directly with a match while keeping
the manual pilot regulator pressed in for approx-
imately one minute after the pilot is ignited. Then
release the manual pilot valve regulator. If the pilot
goes out, wait for five minutes and repeat the
instruction above.
Piezo ignition:
Move the ignition cable from the receiver to the
valve; see the previous figure. Press the Piezo
ignition. If the pilot goes out, wait for five minutes
and repeat the instruction above.
If the pilot continues to go out after several
attempts, switch the gas regulator button (main
valve button) to OFF and proceed to step (8).
5. If applicable, put the pilot access panel back in
place before continuing.
6. Turn the MANUAL button to the ON position,
entirely counter-clockwise
7. Turn the MANUAL button to the ON position,
entirely counter-clockwise
8. If the appliance does not work, follow the instruc-
tions under "Switch off gas to stove".

Switch off gas to stove

If the gas regulator is accessible, turn the main valve
button to the OFF position, completely clockwise
.
If the stove will not be used for an extended
period, close the gas valve in the gas supply
pipe as well.

Combustion control

When the stove is still fairly cold, the flames of the
main burner are very blue during ignition. As the stove
heats up to operating temperature, the flames will
.
27