Remington EL-8: 107624-01 Manual Para El Usuario página 22

Sierra eléctrica
Ocultar thumbs Ver también para EL-8: 107624-01:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Note: For additional help, visit DESA
International's technical service web site at
www.desatech.com.
OBSERVED FAULT
Saw runs, but does not cut
Saw does not cut unless heavily
forced. Cutting produces only saw-
dust with few large chips
Saw runs slow. Saw stalls easily
Motor of saw does not run when you
squeeze trigger
Motor of saw runs, but chain does
not move
Chain does not get oil
Chain comes off guide bar
Saw smokes
Saw leaks oil
www.desatech.com
Brought to You by www.snapwhole.com
POSSIBLE CAUSE
Chain assembled backwards on guide
bar
Chain is dull
Low power supply voltage
1. Switch lockout not pushed for-
ward in to release trigger
2. Extension cord connections loose
3. Open line fuse or circuit breaker
4. Worn out motor brushes
5. Open wiring circuit on saw
Gear train failure
All Models
1. Clogged oil slot in guide bar
2. Oil is too thick
Models with Automatic Oiler
1. Vent in oil cap clogged
2. Filter in oil reservoir clogged
3. Pump damaged, do not use saw
1. Chain is loose
2. Guide bar and chain not as-
sembled right
Saw damaged. Do not use saw
Oil cap is not secure
WARNING: Unplug chain saw from
power source before servicing. Severe
injury or death could occur from electrical
shock or body contact with moving chain.
REMEDY
See Assembly, page 16
See Sharpening Saw Chain, pages
20 and 21
Extension cord wire size too small.
See Extension Cords, page 17
1. Push switch lockout forward be-
2. Check cord connections
3. Check line fuse or circuit breaker
4. See authorized service center
5. See authorized service center
See authorized service center
1. Remove guide bar and clean oil
2. Use correct weight of oil. See
1. Remove cap and clean vent hole
2. Remove filter in oil reservoir and
3. See authorized service center
1. Tighten chain. See Saw Chain Ten-
2. See Assembly, page 16
See authorized service center
Tighten oil cap. Note: Empty oil
tank when not in use
22
fore squeezing trigger
slot
Filling Oil Tank, page 17
clean
sion Adjustment, pages 16 and 17
107705

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

107624-02107625-01107625-02111174-01

Tabla de contenido