Install The Blower; Install Light Bulbs - Broan Elite E60000 Serie Instrucciones De Instalación

16. INSTALL THE BLOWER

Refer to instructions included with blower.
Plug the 3-prong plug cord from rough-in plate to the 3-prong male
connector inside the hood (A) and the 2-prong male connector cord from rough-in
plate to the 2-prong plug inside the hood (B).
Do not plug the 2 cords together.
17. REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS
Reinstall grease drip rail. The illustration beside shows how to reinsert the grease
drip rail into the range hood.
Remove protective plastic film covering filters before installing them.
NOTE:Assemble the metal handles
to the filters, using provided
no. 8-32 x 1/4" screws, before
installing them in the hood.
It is recommended to install side
filters first and finish with center one(s).
1. Insert one end of the filter into the
upper channel of the hood.
2. Raise the other end toward the
inside of hood and insert in the
grease drip rail of the hood.

18. INSTALL LIGHT BULBS

In order to prevent the risk of personal injury, do not install a
lamp identified for use only in enclosed fixtures.
This hood must use 50W, 120V with GU10 base, shielded halogen bulbs (not
included). (2 required for 30" and 36" hood width or 3 for 42" and 48" hood width.)
1. Install bulbs by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
In order to prevent the risk of personal injury, the halogen bulbs must be cooled down before removing
them.
To remove bulbs, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
All manuals and user guides at all-guides.com
(EXTERIOR OR IN-LINE BLOWER)
WARNING
!
CAUTION
1
HD0245
WARNING
!
WARNING
!
HE0078
HD0244
HO0090
- 12 -
B
2
1 2
A