Hold Function; The Use Method Of Computer Rs232 Socket; Function Settings; Weighing - Baxtran APM Manual De Usuario

EN EN

5. HOLd fUNCTION

Once the key is pressed:
A. The CPU will send weight data into RS232 socket.
B. The weight will remain on the display for 120 seconds after the item has been removed from the scale so the weight can easily
be read.
1. Place the item on the scale platform.
2. Wait for the stable weights to be displayed.
3. Press . The "●" hold indicator will turn-on.
4. Remove the item from the scale platform. The item's weight reading will remain on the display for 120 seconds.
5. Quit to hold function: once an item is weighed and the hold function is enabled; you want to quit to hold function, press
key again to cancel the "●" hold indicator and return the scale to weight value.

6. THE USE METHOd Of COMPUTER RS232 SOCkET

REfER TO PHOTO dISk.
ASC II code receive parameter (the RS232 transfer parameter)
Baud Rate
Parity bit
Data bit
Stop bit

7. fUNCTION SETTINgS

1. Enter function setting mode.
Press to turn the power off. Press
2. Selection of auto shut off mode.
When the balance enter function setting menu. Press
display A_ON, this means auto shut off function active. Press
function inactive.
3. Selection of auto backlight mode
When the balance enter function setting menu. Press
L_ON, this means auto backlight function active, press
inactive, i.e. shut off backlight function.

8. WEIgHINg

› BEfORE WEIgHINg
Whenever possible, please allow the scale to warm up for several seconds after first turning the power on so that the scale will
function properly and accurately.
Error messages
EEEE: Overload
: Low battery
16 16
9600
none
8
1
first, then press
key, the display will show A_ON or A_OFF. Press
key, the display will show L_ON or L_OFF, press
again, the display will show L_OFF, this means auto backlight function
, while keeping , the display will show A_ON or A_OFF.
again, the display will show A_OFF, this means auto sut off
APM APM
key, selection
, selection display