Operation Pi Pressure/Cop Mode - S&P CAB ECOWATT PLUS Manual De Instrucciones

6.6.2. Operation PI PRESSURE/COP mode

In section 5 we have described that the fan comes from factory ready to work in constant pressure mode. However, it is also
possible to connect an external pressure transducer (0-10V or 4-20mA) that should be connected to J5 or J6 terminals.
After selecting the operating PI PRESSURE/COP mode, you can confi gure following parameters:
MIN-OUTPUT
< 20% OK
OK OK
MAX-OUTPUT
< 100% OK
OK OK
SETUP LEVEL 2?
< NO SI
YES
OK OK
ENTER PASSWORD:
1 1 1 OK
OK OK
CHANGE PASSWORD
SI NO
NO OK OK
Operation PI PRESSURE/COP mode
Press or to manually modify the minimum
output parameter to the motor
Press or to manually modify the maximum
output parameter to the motor
Access to advanced configuration parameters
Enter the password
Default: 1 1 1
It is possible to assign a new password to your device
(channel)
46