Identification Data; How To Make Coffee - ARIETE CIALDISSIMA MP50 Manual Del Usuario

Identification data

The following machine identification data are shown on the plate placed underneath the machine's standing base:
• manufacturer and CE mark
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number
Always give the model and serial number to the Authorised Service Centres when requesting assistance.
InsTrucTIOns fOr use
Using the appliance for the first time
Check that the voltage of the domestic network is the same as that indicated on the technical information plate of the appli-
ance. Place the appliance on a stable surface.
Before using the appliance for the first time wash the tank. Fill it up with fresh cool water and insert it in its housing (Fig. 4). Insert
the plug into the socket, which must be earthed.
Starting the first time
After having filled the tank with cool tap water, start the machine by pressing the button (P). Indicator lamps (S) turn on to
indicate that the machine is on and that the internal boiler has started to heat up. The machine will be ready for the coffee
when the indicator lamp (R) turns on.
Warning!
Remove at least one cup of water from the boiler hydraulic circuit whenever the appliance is turned on the first time
or after it has not been used for a period of time by pressing the dispensing button (Q) until water starts coming out
of the coffee dispenser (Fig. 7). Do this only after making sure there is no pods inside the pods holder (L).
Warning!
Do not press the dispensing button with the pod holder cover raised. Danger of burns!

hOW TO MAke cOffee

Using the lever (F), lift the pod holder cover and insert the pod in the direction shown (Fig. 5). Close the cover again by
pressing the lever (F) until you hear it click (Fig. 6).
Warning!
Put only pods inside the pod holder. Do not put any powder substance inside.
check that the steam function button (n) has not been unintentionally pressed.
To be sure the first cup of coffee is hot, it is best to leave the pod holder cover closed for a few minutes before putting the
pod inside. This will not be necessary for the cups of coffee that follow. Wait until the lamp (R) turns on before dispensing
the coffee. To savour the coffee at its maximum deliciousness, pre-brew it by pressing the dispensing button (Q) for two or
three seconds, then release it. The blend in the pod will become damp, taking on greater body. Press the button (Q) again
after a few seconds to start dispensing the coffee Fig. 8. Press the button (Q) to stop it. The coffee will thus be even tastier
and more aromatic. The maximum dose for one cup of espresso is 50 ml.
Warning!
Do not open the pods holder cover while coffee is being dispensed; danger of burns!
After the coffee is made, gradually open the pod holder cover by lifting the lever (F). Pay attention that water residue in the
pod holder does not squirt on you. A special snap release device lets you empty the used pod into the pods drawer (J) Fig. 9.
If the machine stays on for a long time, the lamp (R) will turn on and off periodically. This shows that the boiler thermostat
is tripping, which serves to keep the water temperature optimum. It is a good idea to start dispensing the coffee only when
this indicator lamp is off, and this is true for both the first cup and those that follow.
filling the water tank during use
No special operation is necessary when the water in the tank runs out as the machine is equipped with a special self-priming
device. Just unplug the machine, pull out the tank and fill it with fresh cool water again up to the "MAX" level.
12