Maintenance - Husqvarna K 970 III Manual Del Usuario

4. Push the choke control to disable the choke. The
start throttle stays in position.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
WARNING: Do not wind the starter rope
around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION: Do not pull the starter rope
fully and do not let go of the starter rope
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
1429 - 001 - 16.04.2020
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To stop the product
• Move the STOP switch to the right to stop the
engine.

Maintenance

repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
handle when the starter rope is
extended. This can cause damage to the
product.
WARNING: The cutting blade continues to
rotate for a while after the engine stops.
Make sure that the cutting blade can rotate
freely until it fully stops. If it is necessary to
stop the cutting blade quickly, let the cutting
blade lightly touch a hard surface. Risk of
serious injury.
25