Bosch Benchmark B30 Serie Instrucciones De Uso página 22

en-us
Fault
The Ice Maker does not make
enough ice or the ice is
deformed.
The Ice Maker does not make
any ice.
Ice forms in the inflow hose
to the Ice Maker.
Water runs from the appliance. The Water Connection Hose is not
22
Possible cause
The appliance or Ice Maker has only
just been switched On.
A lot of ice has been taken.
Low water pressure.
The Filter Cartridge is damaged
or used.
The Ice Maker is switched Off.
The appliance is not supplied with
water.
Water Supply has kinks.
Low Water Pressure.
Temperature in the freezer space is
too warm.
Ice Cube Container is not properly
inserted.
Incorrect Shut Off Tap installed.
Low Water Pressure.
Shut Off Tap incorrectly opened.
Temperature in the Freezer
Compartment is too warm.
properly sealed.
Incorrect Shut Off Tap installed.
Remedial action
Approximately 24 hours is needed until ice
production starts.
Approximately 24 hours is needed until
the Ice Cube Container is filled again.
Connect the appliance to the stipulated
water pressure only (see chapter
"Connecting Appliance", section "Water
Connection").
Exchanging the Filter Cartridge.
Switch the Ice Maker On at the control
panel.
Contact the installer or the Water Supply
company.
Turn Off the Water Supply at the Shut Off
Tap. Smoothen out the kinks, exchange
where necessary.
Connect the appliance to the stipulated
water pressure only (see chapter
"Connecting Appliance", section "Water
Connection").
Check Freezer Compartment temperature
and, if required, set slightly colder.
Check the position, re-insert where
necessary.
Incorrect Shut Off Taps can cause low water
pressure and damage to the appliance.
Connect the appliance to the stipulated
water pressure only (see chapter
"Connecting Appliance", section "Water
Connection").
Open Shut Off Tap fully.
Set temperature slightly colder
in the Freezer Compartment.
Replace the hose with a manufacturer's
original part.
Incorrect taps can cause low water pressure
and damage to the appliance.