Dremel 100 Instrucciones De Funcionamiento Y Seguridad página 11

1600A011JA.qxp_100 200 3000 4/12/17 12:55 PM Page 11
BALANCING ACCESSORIES — For precision
work, it is important that all accessories be in
good balance (much the same as the tires on
your automobile). To true up or balance an
accessory, slightly loosen collet nut and give the
accessory or collet a 1/4 turn. Re tighten collet
nut and run the Rotary Tool. You should be able
to tell by the sound and feel if your accessory is
running in balance. Continue adjusting in this
fashion until best balance is achieved. To
maintain balance on abrasive wheel points,
before each use, with the wheel point secured in
the collet, turn on the Rotary Tool and run the
415 Dressing Stone lightly against the revolving
wheel point. This removes high spots and trues
up the wheel point for good balance.
The hanger is provided for the use of hanging
your tool while using the flex-shaft or for
The Rotary Tool is a handful of high-speed
power. It serves as a carver, grinder, polisher,
sander, cutter, power brush, drill and more.
The Rotary Tool has a small, powerful electric
universal motor, is comfort able in the hand,
and is made to accept a large variety of
accessories including abrasive wheels, drill
bits, wire brushes, polishers, engraving cutters,
router bits, cutting wheels and attachments.
Accessories come in a variety of shapes and
permit you to do a number of different jobs. As
you be come familiar with the range of
accessories and their uses, you will learn just
how versatile the Rotary Tool is. You'll see
dozens of uses you hadn't thought of before.
The real secret of the Rotary Tool is its speed.
To understand the advantages of its high
speed, you have to know that the standard
portable electric drill runs at speeds up to
2,800 revolutions per minute. The Rotary Tool
operates at speeds up to 35,000 revolutions
per minute. The typical electric drill is a low-
speed, high torque tool; the Rotary Tool is just
the opposite – a high-speed, low torque tool.
The major difference to the user is that in the
high speed tools, the speed combined with the
acces sory mounted in the collet does the work.
You don't apply pressure to the tool, but simply
hold and guide it. In the low speed tools, you
not only guide the tool, but also apply pressure
to it, as you do, for example, when drilling a hole.
storage. If you do not use the hanger, remove it
from the tool and snap it back into place
underneath the cord so it will be out of the way
while the tool is in use.
FIXING STUCK COLLETS – It is possible for a
collet to get stuck within the collet nut especially if
a collet nut is tightened onto the tool without a bit
in place. If this happens, the collet can be
removed from the collet nut by pushing the shank
of an accessory into the hole in the collet nut.
This should cause the collet to pop out of the
collet nut.
Operating Instructions
Sharpen Tools
Shape Wood
Deburr Metal
Drilling
Carve Wood
Cut Metal
11