Makita TD020D Manual De Instrucciones página 5

switch can be actuated.
Switch action
1
007511
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch actuates
properly and returns to the "OFF" position when
released.
To start the tool, first move the lock button to the
released position to release the switch.
simply push the switch on the
rotation and the
rotation Release the switch to stop.
CAUTION:
Always check the direction of rotation before
•
operation.
Change the direction only after the tool comes to a
•
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
When not operating the tool, always place the lock
•
button in the locked position .
Lighting up the front lamp
007512
1
007513
1. Switch
side for the clockwise
side for the counterclockwise
1. Lamp switch
1
1. Lamp
CAUTION:
Do not look in the light or see the source of light
•
directly.
To put on the light, first slide the lamp switch to the
position and then push the
Release it to stop.
NOTE:
When the lamp switch is in the locked position ,
•
lamp switch cannot be actuated.
CAUTION:
Always slide the lamp switch to the locked
•
position
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
And then
CAUTION:
Always be sure that the lock button is in the locked
•
position
removed before carrying out any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
1
007509
5
mark on the lamp switch.
when not operating the tool.
mark and the battery cartridge is
9 mm
(3/8")
1. Bit
2. Sleeve
2