Graco 8485 El Manual Del Propietario página 16

To Install Locking Clip:
1. Tighten the buckled
belt by pushing down
hard on the car seat
and pulling hard on the
shoulder belt.
2. While pushing down on
seat, pinch the two straps
together behind the the
buckle tongue. Unbuckle
½
the belt without allowing
inch
it to slip.
3. Connect lap and
shoulder belts as
shown .
4. Rebuckle belt. Check
that lap belt does not
move by pulling hard. If
belt loosens or lengthens,
repeat procedure.
Remove locking clip when
not using car seat. Store
under it's tab on the back
of seat.
16