Honeywell RTH6350 Serie El Manual Del Propietario página 16

Auto Changeover (RTH6450 and RET95E only)
Use this feature in climates where both air conditioning and heating are used on
the same day. When the system mode is in Auto, the thermostat automatically
selects heating or cooling depending on the indoor temperature.
While in the Auto mode, if a schedule override takes place (temporarily or
permanently) the thermostat will automatically adjust the cooling and heating
settings to maintain a 3-degree separation between the cool and heat settings.
For example, if the heat temperature is raised to where it gets within 3-degrees
of the cool setting, the display will show an up arrow next to "cool" to show the
thermostat is raising the cool setting up to maintain a 3-degree separation.
Press the Select Heat/Cool button to select between the heat and cool to view/
adjust either mode.
Inside
73
1 : 05
Fan
Run Schedule
Auto
NOTICE: To avoid possible compressor damage, do not use Auto
Changeover if the outside temperature drops below 50ºF (10ºC).
Temporary
Heat
Setting
73
PM
Cool
Select
Heat/Cool
M27477
16