Campbell Hausfeld CE2000 Serie Instrucciones De Operacion Y Lista De Partes página 7

Operation (Continued)
START-UP
To ensure proper operation, unit must be on a
level surface.
1. Fill engine with oil and gasoline per instructions furnished
with engine.
2. Check oil sight glass to verify proper oil level.
3. Turn manual unloader lever up to a horizontal position to
allow the compressor pump to run without compressing air.
TO START GASOLINE ENGINE
1. Move the choke lever to the CHOKE position, turn the fuel
lever ON, and turn the engine stop switch to the ON position.
2. Pull start grip lightly until resistance is felt, and then pull
briskly.
3. As the engine warms up, gradually move the choke lever to
the open position. See gas engine manual for more details.
4. Run the compressor unloaded for approximately 30 minutes
to break in the pump.
5. After approximately 30 minutes, move the unloader lever
down to the loaded position. The compressor will begin to
pump air into the tank.
When maximum tank pressure is reached, the compressor
automatically unloads, bringing the engine to idle. The engine
remains at idle until tank pressure falls to a preset level. The
engine then accelerates and the compressor pumps additional
air into the tank.
MOISTURE IN COMPRESSED AIR
Moisture in compressed air will form into droplets as it comes from an air compressor pump. When humidity is high or when a
compressor is in continuous use for an extended period of time, this moisture will collect in the tank. When using a paint spray
or sandblast gun, this water will be carried from the tank through the hose, and out of the gun as droplets mixed with the spray
material.
IMPORTANT: This condensation will cause water spots in a paint job, especially when spraying other than water based paints. If
sandblasting, it will cause the sand to cake and clog the gun, rendering it ineffective. A filter in the air line, located as near to the
gun as possible, will help eliminate this moisture.
Manual Unloader Lever in the
Unloaded Position
Figure 6
Manual Unloader Lever in the
Loaded Position
Figure 7
Series CE2000
www.chpower.com 7