Campbell Hausfeld CE2000 Serie Instrucciones De Operacion Y Lista De Partes página 9

Maintenance (Continued)
DRIVE BELT
Belt stretch is a result of normal use. When properly adjusted, the belt deflects about
1/2 inch with five pounds of pressure applied midway between the engine pulley and
pump.
To adjust drive belt tension:
1. Remove belt guard and loosen engine brace.
2. Loosen the four fasteners holding the engine to the baseplate.
3. Shift the engine in the proper direction. The belt must be properly aligned when
adjustment is made.
4. To align belt, lay a straight edge against the face of the flywheel, touching the rim at
two places.
5. Adjust flywheel or engine pulley so that the belt runs parallel to the straight edge.
6. Use a gear puller to move the pulley on the shaft and tighten fasteners.
7. Adjust brace and reinstall belt guard.
STORAGE
1. When not in use, hose and compressor should be stored in a cool, dry place.
2. Tanks should be drained of moisture.
3. Hose should be disconnected and hung with open ends down to allow any moisture
to drain.
Series CE2000
1/2 inch Deflection
Figure 10
Belt
Figure 11
www.chpower.com
Straight
Edge
Touch Rim
of Flywheel
in Two
Places
9