Assembly - Ryobi JS480L Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Jig Saw
Wood Cutting Blade
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
INSTALLING BLADE
See Figure 2, page 13.
NOTE: The jig saw is designed to use both T-shank and
U-shank blades.
 Unplug the saw.
 Lift the clamping lever on the rapid-change blade clamp
until it stops.
 Holding the clamping lever up, insert the saw blade (with
blade teeth facing out) as far as possible into the slot in
the saw bar.
 Check to make sure the back of the saw blade is centered
in the groove of the roller guide.
 Release the clamping lever. Make sure the blade is
securely in place.
8 — English