Ottobock 4023 Manu Rheuma Instrucciones De Uso página 11

2) Determine the size of the support (see size chart).
4.2 Adaptation
CAUTION
Incorrect or excessively tight application
Skin irritation due to overheating, local pressure points due to tight applic­
ation to the body
► Ensure that the support is applied properly and fits correctly.
► Do not use the product in case of a known heat allergy.
► When in doubt, do not continue to use the product if skin irritation
occurs.
> Open all hook-and-loop closures.
1) Remove plastic splints from the support.
2) Heat and adjust the plastic splints.
3) After they have cooled off slightly, insert the plastic splints in the support
and close the hook-and-loop closures.
4.3 Application
> Open all hook-and-loop closures.
1) Pull the support over the wrist, placing the loop over the thumb.
2) Fasten all hook-and-loop closures (see fig. 1 and see fig. 2).
→ The support fits snugly without pinching.
4.4 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
1) Take out all removable splints.
2) Fasten all hook-and-loop closures.
3) Recommendation: Use a laundry bag or net.
4) Wash the support in warm water at 40 °C with standard mild detergent.
Do not use fabric softener. Rinse thoroughly.
5) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight,
stove or radiator).
6) Reinsert all splints.
Ottobock | 11