BH FITNESS G6434 Instrucciones De Montaje Y Utilización página 15

ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.1.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(1) Main structure; (4L) Side bar (left);
(4R) Side bar (right); (7) Transverse
bar; (13) Allen screw M-8x45; (14)
Allen screw M-8x15; (15) Self-tapping
screw ST4x20; (26) Monitor; (28)
Safety key; (124) Allen key; (127)
Bottle of lubricant.
Follow the instructions step by step to
assemble:
FITTING THE SIDE RAILS.-
1 First, take the right-hand side bar
(4R) and connect terminal (61) coming
out of the main body (1) to terminal
(103) coming out of the bottom part of
the side bar (4R) Fig.2.
Then, insert the side bar in the
direction of the arrow, in the bottom
right-hand support of the main body
(1) and fix the front with screws (14)
and the side with screws (13).
2 Next, take the left-hand side bar (4L)
and insert the side bar in the direction
of the arrow, in the bottom left-hand
support of the main body (1) and fix
the front with screws (14) and the side
with screws (13).
Fig.B 3 At least two people are needed for this
step. When fitting the side bars, one
person should hold the side bar while
the other one fits the screws (14) and
(13). This will prevent any possible
accidents.
4.- FITTING THE TRANSVERSE
BAR OF SIDE BARS.-
Place the transverse bar (7) in the
upper part of the right-hand bar (4R)
Fig.3.
Insert the transverse bar in the hole
and secure it using screw (15).
Next, insert the bar in the hole of the
left-hand side bar (4L) and secure it
using screw (15) Fig.3.
5.- FITTING THE MONITOR:
Connect the control cable terminal (H)
Fig.4, coming out of the monitor, to the
control cable (20), sticking up from the
right-hand side bar (4L), connect the
terminals for the feedback cables (C-
F) coming out of the monitor to the
cable (103-21) sticking up out of the
handlebar stem, Fig.4, and insert
screws (24), making sure not to pinch
the cables, and screw in until hand tight.
ATTENTION: Cylinder (54) Fig.5 is
factory set to high pressure so it must
not be knocked. If it is knocked this
may damage
operation of the treadmill.
FOLDING YOUR UNIT.-
This treadmill is equipped with a
folding mechanism
purposes. To use it, stop the treadmill,
lower the elevation level to minimum,
unplug the mains cable and lift the unit
until you hear lever (O) click into
place, Fig.6. Store your unit in a dry
place, preferably
changes in temperature.
15
it and impair
for storage
not subject
the
to