SCHOLTES FN 36 XA S Manual De Instrucciones página 28

• The inside of the oven should ideally be cleaned after
GB
each use, while it is still lukewarm. Use hot water and
detergent, then rinse well and dry with a soft cloth. Do
not use abrasive products.
• All accessories - with the exception of the sliding racks
- can be washed like everyday crockery, and are even
dishwasher safe.
! Never use steam cleaners or pressure cleaners on the
appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with a
soft cloth. Do not use rough abrasive material or sharp metal
scrapers as these could scratch the surface and cause the
glass to crack. For more thorough cleaning purposes, the
oven door may be removed:
1. Open the oven door fully (see diagram).
2. Lift up and turn the small levers located on the two hinges
(see diagram).
F
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.
Replacing the light bulb
Oven
compartment
Lamp
Seal (only on a
few models)
Glass door
! Do not use the oven lamp as/for ambient lighting.
28
F
3. (with glass panel fitted to the
inside of the door) Grip the door
on the two outer sides and close
it approximately half way. Unlock
the door by pressing on the clamps
F, then pull the door towards you,
lifting it out of its slot (see diagram).
To replace the oven light bulb:
1. Remove the glass cover
using a screwdriver.
2. Unscrew the light bulb and
replace it with a similar one:
Wattage 15 W, cap E 14.
Replace the glass cover,
making sure the seal is
positioned correctly (see
diagram).
Sliding rack kit assembly *
A
Left
Right guide
guide rail
rail
B
C
D
! Do not place the sliding racks in position 5.
*
Only available in certain models.
To assemble the sliding
racks:
1. Remove the two frames,
lifting them away from the
spacers A (see figure).
2. Choose which shelf to use
with the sliding rack. Paying
attention to the direction in
which the sliding rack is to
be extracted, position joint B
and then joint C on the
frame.
3. Secure the two frames
with the guide rails using the
holes provided on the oven
walls (see diagram). The
holes for the left frame are
situated at the top, while the
holes for the right frame are
at the bottom.
4. Finally, fit the frames on
the spacers A.