EINHELL TC-MG 220/1 E Manual De Instrucciones página 16

4. Technical data
Mains voltage: ...................220-240 V ~ 50-60 Hz
Power input: .............................................. 220 W
Idling speed: ............................ 11000-22000 rpm
Sanding/grinding area: .............. 90 x 90 x 90 mm
Oscillation angle: ...........................................3.2°
Protection class: ............................................ II/
Weight: .....................................................1.65 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ..................... 84.5 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ....................... 95.5 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Handle
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Anl_TC_MG_220_1_E_SPK9.indb 16 Anl_TC_MG_220_1_E_SPK9.indb 16
= 3.611 m/s
2
h
2
- 16 -
GB
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the plug-in tools (Figures 1/2)
•
To fit the plug-in tools safely you should hold
the multifunction tool so that the ON/OFF
switch (1) points down and the tool mounting
(2) faces up.
•
Place the plug-in tool (e.g. the triangular
grinding/sanding plate or Saw blade) on the
tool mounting (2) so that the pins of the tool
mounting (2) fit into the recesses in the plug-
in tool.
•
Secure the plug-in tool using the supplied
screw (5) and tighten the screw securely with
the Hexagon key (11).
•
Make sure that the washer (4) is used for the
screw (5) (see Figure 2). The camber on the
washer must face upwards.
23.08.2017 08:10:41 23.08.2017 08:10:41