Maruyama E23 Manual Del Propietario Y Operador página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.
Move the choke lever to the closed (
and move the stop switch to the "ON" position.
Choke Lever
STOP
Stop Switch
Fast-idle lock
WARNING
POTENTIAL HAZARD
• The components of your recoilstarter
assembly are under high spring tension.
If improperly disassembled these parts
maystrike you with considerable force,
possibly causing personal injuly.
WHAT CAN HAPPEN
• Contact with the parts can cause sever-
er personal injur y.
HOW TO AVOID THE HAZARD
• Never attempt to disassemble your
recoil starter assembly yourself.
Always consult your authorized
Maruyama dealer for repair by qualified
ser vice technicians.
3.
Lock the throttle trigger in the fast-idle start posi-
tion, then pull the starter grip.
All manuals and user guides at all-guides.com
) position
Starter Grip
START (ON)
Throttle Trigger
(In fast-idle start
position)
Throttle Trigger
(In idle position)
— US-18 —
After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
If the engine stops running before you move the
choke lever to the open (
A. Go ahead and open the choke.
B. Make sure the throttle trigger is set to the idle
position.
C. Pull the starter grip until the engine starts.
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1.
Pump the primer bulb at the bottom of the carbu-
retor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2.
Move the choke lever to the open (
and move the stop switch to the "ON" position.
3.
Leave the throttle trigger in the idle position and
pull the starter grip.
4.
If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (page19).
If the engine fails to start after you follow the
above procedures, contact an authorized
Maruyama dealer.
To Stop The Engine:
1.
Release the throttle trigger.
2.
Slide the stop switch to the "STOP" position.
) position.
) position:
) position

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

E27

Tabla de contenido