Assembly; Assembling Engine And Drive Shaft Assembly; Loop Handle Installation - Maruyama E23 Manual Del Propietario Y Operador

Assembly

Assembling Engine and Drive
Shaft Assembly
The drive shaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the
engine using the four M5 x 20 screws supplied with the
unit.
Engine

Loop Handle Installation

The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
Screw (4)
Nut (4)
All manuals and user guides at all-guides.com
M5 x 20 Screw (4)
Shaft
Clutch Drum Housing
Loop Handle
Rubber Sleeve
Bottom Clamp
— US-12 —
1. Slip the rubber sleeve around the shaft approxi-
mately 9 inches (22.8 cm) from the end of the stop
switch/throttle trigger assembly for an initial han-
dle position.
2. Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over
the rubber sleeve.
4. Install the four screws and nuts. Leave the screws
finger-tight.
5. Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
6. Tighten the screws and nuts.