Top Panel - ION Vinyl Motion Air Guia De Inicio Rapido

Features

Top Panel

12
1. Platter: Place your record here.
2. 45 RPM Adapter Holder: Holds the included 45 RPM adapter. When not using the adapter, please
place it in this holder.
3. Tonearm: The fixed tonearm can be raised and lowered by hand, or by pressing the raise / lower
lever.
4. Arm Clip: This specially designed arm clip secures the tonearm while at rest or when not in use. The
arm clip has been designed to remain in the up position while unlocked.
5. Raise / Lower Lever: Raises and lowers the tonearm.
6. 33 / 45 / 78 Switch: This switch controls the RPM of the turntable platter.
Note: For best results when playing 78 RPM vinyl
records, use a 78 stylus (sold separately). Only use a
78 stylus with 78 RPM vinyl records.
7. Autostop switch: This switch turns autostop on or off.
When autostop is on, the platter will start spinning
when the tonearm is placed over the record and stop
spinning when the record has reached the end. (When
autostop is off, the platter will always spin regardless
of the position of the tonearm.)
Note: If your vinyl record stops before it reaches the
end of the music, turn Autostop to the off position for
this particular record. This is generally recommended
for 45 RPM records.
1
2
3
4
12
IMPORTANT: Place the included felt slipmat
on the platter; then place your record on the
felt slipmat to carefully hold your records.
IMPORTANT: Remove the plastic cartridge
cover (needle cover) before operating the
turntable.
*WARNING: The RCA outputs are LINE level.
Please only connect these to LINE level
inputs. You may damage your receiver if you
plug in a LINE level device into a PHONO
level input.
5
14
15
6
13
7
16
11
10
8
9
5