Start Up - Truper SOMU-250X Instructivo

Start Up

Connection Configurations
CAUTION
• All the connections in the control panel shall be perfectly tight in their power supplies. To secure the
connections turn clockwise.
• The electrode polarity can be modified depending on welding work requirements or needs. Remember to make trial test
in scrap material to define the right configuration before working on the work piece.
Connection of the ground clamp into the
negative terminal (–) and connection of
the torch to the positive (+) terminal.
The electrode receives the higher
heating. Recommended to wel
with gas and solid micro
wire.
NOTE:
For the "MIG ALUMINUM, MIG STAINLESS STEEL, MIG CARBON STEEL, MIG COPPER SILICON functions,
values are pre-established by the machine software. The adjustment depends of the type of material to work with.
MIG Weld
Interface Home Minimum and maximum parameters of the manual MIG process
2.2
MIG Manual
MIG Manual
2T
Connection of the torch into the negative
terminal (–) and the ground clamp to the
positive terminal (+). The work piece
receives the highest heating.
Recommended to weld without
gas and core micro wire.
m m
13.0 V 13.6 28.0 V
min min
00
MIG Manual
t t
2T
00
ENGLISH 13