Technical Data; Power Requirements - Truper SOMU-250X Instructivo

Technical Data

Voltage
Current
Welder Process
Open circuit Voltage
Current Range
Duty Cycle
Micro Wire Diameter
Micro Wire speed
Electrode diameter
Cooling Type
Insulation
Conductors
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING Before gaining access to the terminals all power sources should be disconnected.

Power Requirements

WARNING
• The tool shall be connected to ground while in use to prevent an electric shock.
The welder shall be installed as close as possible to the main power supply. Double check the power supply has the same voltage
than the one indicated in the motor nameplate.
WARNING
• This device shall be grounded.
• The power cables are codified with the following colors:
CAUTION
• If using the welder together with more tools sharing the same ground, connect the tools in parallel. Never connect in a series.
CAUTION
• The ground conductor cable gauge cannot have a lower gauge than the power supply cable.
CAUTION
• The connection to the power source shall be carried out by a professional electrician.
• Confirm always that the input connection voltage stipulated in the welder nameplate matches the
CAUTION
power supply voltage.
CAUTION • The power supply cable gauge shall comply with the following requirements:
Switch
Fuse (Rated working Current)
Electric Wire
* The fuse fusion current is double of the rated current.
SOMU-250X
Code
17259
220 V
53 A
MIG : 77 V c.c. | TIG: 13 V c.c. | SMAW : 77 V c.c.
MIG : 18 A - 250 A | TIG: 13 A - 250 A | SMAW : 20 A - 220 A
SMAW: Type: 6013
Type: 7018
TIG: 1 mm | 1,6 mm | 2 mm | 2,4 mm
Class I
30 A
40 A ( * )
2,5 mm
2
Description
Input
Input Rated Capacity
Output
MIG, TIG y SMAW
60% - 6 minutes' work per 4 minutes' rest.
The output values are given in a 68 ºF temperature.
In higher temperatures, the duty cycle may be reduced.
0,023" | 0,031" | 0,035" | 0,039" | 0,043"
7.2 ft / min - 44.6 ft / min
3/32" | 1/8" | 5/32" | 3/16"
3/32" | 1/8" | 5/32"
Fan Forced
IP Grade
12 AWG x 3C cwith 221 °F insulation temperature
Power cord grips used in this product: Type "Y".
Build quality: Basic insulation
Thermal insulation on motor winding: Class H
• In the event of needing extension cables between the
welder and the work piece, increase the welding cable
gauge to keep the welder energy output with a potential
drop not higher than 4 V
Multi Process Welder
Frequency
IP21S
Authorized Service Center.
GREEN GROUND
WHITE CURRENT
BLACK CURRENT
ENGLISH
60 Hz
11,6 kVA
3