Start Up; Connection Configurations - Truper EXPERT SOMU-200X Instructivo

Start Up

Connection Configurations

CAUTION
• All the connections in the control panel shall be perfectly tight in their power supplies. To secure the
connections turn clockwise.
• The electrode polarity can be modified depending on welding work requirements or needs. Remember to make trial test
in scrap material to define the right configuration before working on the work piece.
Connection of the ground
clamp into the negative
terminal (–) and connection
of the torch to the positive
(+) terminal. The electrode
receives the higher heating.
Recommended to weld with
gas and solid micro wire.
Interface Home
MIG Manual
NOTE
For the "MIG ALUMINUM, MIG STAINLESS STEEL, MIG CARBON STEEL, MIG COPPER SILICON functions,
values are pre-established by the machine software. The adjustment depends of the type of material to work with.
MIG Weld
Minimum and maximum parameters
of the manual MIG process (110 V).
m
2.2 13.0 V 13.6
min
00
MIG Manual MIG Manual
t
2T 2T
Connection of the torch into the
negative terminal (–) and the ground
clamp to the positive terminal (+).
The work piece receives the
highest heating.
Recommended to weld
without gas and core
micro wire.
m
20.0 V 2.2
min
00
MIG Manual
t
2T
Minimum and maximum parameters
of the manual MIG process (220 V).
m m
13.0 V 13.6 28.0 V
min min
00
MIG Manual
t t
2T
ENGLISH
00
13