NuWave Bravo XL El Manual Del Propietario página 24

INSTRUCTIONS
until it is reached.
6. Press START/PAUSE.
The current internal
Probe temperature will be
displayed.
7. Press TEMP/TIME to
display the set cooking
temperature, default is
350F.
• Press and hold PROBE
for 1 sec. to display the
set temperature of the
Probe. Turn the START/
PAUSE dial to adjust
the Probe temperature,
if desired.
• Press PROBE to
display the current
internal temperature of
your food.
8. Once the set temperature
of the Probe is reached,
the Bravo will stop cooking
and "End" will be displayed.
Notes:
• When the Probe is
unplugged and PROBE
is pressed, "Prb1" (error)
will be displayed and the
Bravo will beep three times.
This indicates PROBE was
pressed but that the Probe
plug was not inserted into
the Probe Input Jack.
• If your cooking temperature
is set lower than the set
Probe Temperature, and
START/PAUSE is pressed,
"Prb2" (error) will be
displayed and the Bravo will
beep three times.
• If Probe temperature was not
reached after preset cooking
time finished, the Bravo will
continue cooking. To see
24 24
instructions
remaining cooking time,
press TEMP/TIME twice (if
not cooking within a timed
countdown). "ON" will be
displayed and stay at "ON",
indicating that the preset
cooking time has run out.
Using Sear 1 2 with Probe
Example: Sear 1 » Stage
1,2,3 » Sear 2 » Warm » Probe
temperature 200F. If the Probe
temperature is achieved (200F)
at stage 2, the Bravo will stop
cooking the remaining stages
but will still cook your food for
the Sear 2 and Warm functions.
To avoid an unsafe condition
(Probe is shunted outside of
the cavity, but oven started
working with the Probe set and
activated), the Bravo will shut
off when:
1. If the target temp is over
250F and the Probe does
not increase in 5F after
60 min, shut the Bravo off
immediately.
Or
2. If the target temp is under
250F and the Probe does
not increase in 5F after
120 min, shut the Bravo off
immediately. "Prb4" will be
displayed.
Note: To cancel any function
or stage during the cooking
cycle, press TEMP/TIME (if
not cooking within a timed