Liquid Propane (Lp) Safety Information - LANDMANN 45025 Manual De Instrucciones

Liquid Propane (LP) Safety Information

Please review the below guidelines and safety information when using Liquid Propane (LP) gas.
General Information
• This grill is designed certified by ETL for use with a
standard 20 lb. LP gas cylinder.
• This grill CANNOT be converted to natural gas.
DO NOT attempt to convert this grill with a different
gas type.
Safety Information
• LP gas has an odor similar to natural gas.
• LP gas is heavier than air and leaking gas may collect
in low areas and resist dispersion.
• LP cylinders should not be dropped or handled
roughly.
• DO NOT use a damaged LP cylinder. A dented or
rusty LP cylinder or an LP cylinder with a damaged
valve may be hazardous and should be replaced with
a new cylinder immediately.
• ALWAYS close the cylinder valve after use.
• ALWAYS close the cylinder valve when disconnecting
the regulator.
• ALWAYS treat possible empty LP cylinders with the
same care as a full LP cylinder. There may still be gas
pressure inside a possible empty LP cylinder.
• NEVER store or transport an LP cylinder where the
temperature can reach 125ºF.
• Keep LP cylinders away from children and pets.
• DO NOT store disconnected LP cylinders in a
building, garage or other enclosed areas.
• If the LP cylinder is kept in the grill between
uses, make sure to keep both the grill and
the cylinder in an outdoor area with good
ventilation.
• ALWAYS leak test the LP cylinder
connection to the regulator when ever
changing LP cylinders.
Installation of LP Cylinder
1. Make sure all burner controls are in the OFF
position.
2. Carefully position in the large hole on the
bottom panel.
3. To secure the LP cylinder in place, screw the
tank holding tray bolt through the bottom
section of the LP cylinder.
4. Attach the regulator to the cylinder by
carefully HAND TIGHTENING only.
5. NEVER use a wrench or other tool to tighten
this connection.
6. Observe all governing codes and
ordinances.
Important
The United States LP gas appliance installation
must conform with local codes and ordinances.
In the absence of local codes, appliance
installation must conform with either the
National Fuel Gas Code, ANSI Z223.1/NFPA54,
Natural Gas and Propane Appliance code,
CSA B149.1, or Propane Storage and Handling
Code, B149.2, as applicable.
For Canada, installation of this grill must comply
with local codes and/or Standard CSA B149.2
(Propane Storage and Handling Code).
5