Cleaning Instructions - Panasonic CS-S9TKV Instrucciones De Operación

Cleaning instructions

To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. A dirty unit may cause malfunction
and you may see nanoe-G indicator blinks or
error code "H99". Please consult authorised
dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fin, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap ( pH 7) or neutral household
detergent.
• Do not use water hotter than 40°C / 104°F.
Indoor unit
Wipe the unit gently with a soft,
dry cloth.
Coils and fans should be clean
for at least every 6 months by
authorised dealer.
Front panel
Wash gently and dry.
Remove the front panel
2 Pull out and lift up
1 Release the
hooks at
both ends
Close it securely
3 Close down
4 Press both ends and center of the front panel
20
ACXF55-04370_YZ0517-1.indb 20 ACXF55-04370_YZ0517-1.indb 20
2 Push in
1 Insert
at both
sides
Indoor unit
Front panel
Human activity
sensor
Air filters
nanoe-G Generator
Once every 2 weeks
• Clean with dry cotton bud.
• Do not touch during operation.
Air filters
Once every 2 weeks
• Wash/rinse the filters gently
with water to avoid damage to
the filter surface.
• Dry the filters thoroughly under shade, away
from fire or direct sunlight.
• Replace any damaged filters.
Remove air filter
For seasonal inspection after extended
non-use
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select COOL
operation. After 15 minutes of operation, it
is normal to have the following temperature
difference between air inlet and air outlet
vents:
COOL: ≥ 8°C/14.4°F
For extended non-use
• Activate nanoe-G operation for 2~3 hours as
an alternative to remove moisture left in the
internal parts thoroughly to prevent mould
growth.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
Aluminium fin
nanoe-G Generator
Attach air filter
Insert into the unit
6/2/2017 2:30:37 PM 6/2/2017 2:30:37 PM