Installation The Switch Housing And Light Kit - Hinkley MARQUIS ILLUMINATED Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION THE SWITCH HOUSING AND LIGHT KIT

NOTE: Be sure the power is off before installing.
1
Remove and discard the plug from the switch housing,
attach the light kit to the switch housing by feeding the
light kit wires (black and white) through the hole of switch
housing and then screw it onto the switch housing by nut
& lock washer. Be sure it is tight enough to prevent light
kit from vibrating loose. (Fig. 1)
While holding the light kit assembly under your fan, snap
2
together the wire connection plugs. (Fig. 2)
3
Carefully push all wires back into the switch housing, then
install the light kit assembly onto the mounting plate with 3
screws provided. Be sure to tighten all screws.
4
Install 4 Watt LED Bulbs (included). (Fig. 2)
Remove the decorative nut, glass cap, metal nut from the
5
light kit. Place glass shade over the light kit stem, secure
with the metal nut, glass cap and decorative nut. Do not
overtighten. Insert the fan pull chain through the eyelet in
the light kit, shade and glass cap. Also insert the light kit
pull chain through the shade and nut. (Fig. 2)
6
Turn the power on. Your Regency Ceiling Fan is now ready
to enjoy!
Nut
Lock Washer
Plug
12
| hinkley.com
Switch Housing
Light Kit
Fig. 1
Wire Connection
Plugs
Light Kit
Assembly
Metal Nut
Glass Cap
Decorative Nut
Mounting
Plate
Screws
Bulbs
Glass shade
Fig. 2

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido