Fuse Replacement - Chauvet DJ COREpar 80 USB Guía De Referencia Rápida

COREpar™ 80 USB QRG
AC Power
Power Linking

Fuse Replacement

IRC-6
(Infrared
Remote
Control)
Mounting
Mounting
Diagram
WARNING! DO NOT plug anything other than a D-Fi™ USB into the
USB port. Doing so may cause damage to the product.
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
For the maximum number of COREpar™ 80 USB that can be power linked at
120 V or at 240 V, see the User Manual or the label on the product.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
The COREpar™ 80 USB is fully compatible with the Infrared Remote
Control (IRC-6) from Chuavet. For more information on the IRC-6 or to
download instructions, go to www.chauvetlighting.com.
Before mounting this product, read the
Clamp
(such as the
CLP-15N from
Chauvet)
Double-bracketed
Yoke for Floor or
Overhead Mounting
Safety Notes.
4
Safety Cable
(such as CH-05
from Chauvet)
Bracket Adjustment Knob
EN